LYNCH GAIN STAGE — private0.1 Set sensible operating level before the next insert, with clear input/output RMS, peak and VU-inspired readings. This is gain staging; it is not mastering loudness normalization or a continuously riding vocal compressor. MANUAL Input Trim sets gain from-36 to+24dB. Output Trim adjusts the level after the optional analog stage. Polarity reverses both channels. Mix0 and Bypass use the same96-sample delayed dry signal. Silence remains silence. Clean Init adds no analog color. The fixed96-sample latency is reported to the host. AUTO Choose Auto, play a representative passage and press Learn. Capture uses complete 100mswindows and needs at least6seconds of useful audio; quiet/silent/DC-only windows do not count. Learn Duration chooses6–20seconds of useful material. Stop can finish earlier once6seconds are available; an insufficient capture cannot be applied. Capture stops after60seconds of wall time if useful material is missing. Any NaN/Inf encountered during capture rejects the proposal. DC-only material does not qualify; a DC Material warning explains why the useful counter stalls. The proposal aims for the chosen Nominal RMS reference, while respecting the Peak Headroom target from the measured8x peak estimate plus0.3dB reserve. If the signal is very dynamic, peak headroom takes precedence; Peak Limited explains why the average level stays lower. Gain changes are bounded-36 to+18dB. Measurements, useful seconds, suggestion and warnings remain visible. Apply commits the suggestion to Input Trim with a smooth change. Gain then stays fixed until you change it or learn again. Auto/Manual switching does not itself change gain. Undo restores only the last Apply trim if it has not been manually edited since. A proposal becomes stale after relevant target/trim/mode changes or state resets. Learn again for new material. Auto stages the signal BEFORE analog coloration; Drive and Output can change the final output level. Watch the output peak meter. Future peaks not in the capture can be higher, and a clipped source cannot be repaired by lowering its level. These are practical limits of any gain estimate. REFERENCE AND COLOR Nominal reference is selectable-24 to-12dBFS, default-18. VU-inspired readings show300ms RMS relative to this chosen reference. They are not a calibrated analog voltage measurement;0VU does not universally equal one particular digital level. Peak readings and RMS are separately labeled. Optional Sample Protect is sample protection, not a true-peak limiter. Clean bypasses analog coloration. Valve adds asymmetric tube-inspired saturation; Transformer adds a transistor/ClassA-inspired low-frequency saturation branch. Circuit On and Drive are independent from Auto. There is no forced hiss. PRESETS AND HELP Auto Profiles choose target settings; they do not magically change gain without Learn/Apply. Init resets to neutral Manual. Save/Load stores your own settings; all sound parameters are exposed to DAW automation. Use ? for contextual help, Guide/Escape for this integrated page and Scale for six screen-bounded sizes. Published context: Focusrite's official gain/headroom guidance, Sound Devices' VU/peak reference explanation and SSL Meter's selectable analog reference. This original software does not adjust physical interface gain or input voltage. Private arm64 AU build. Actual Logic-session audition remains Robin's final QA.