LYNCH ELECTRONIC DRUMS+ USER GUIDE — 0.3.0 ELECTRONIC PULSE. NORTHERN SOUL. A complete electronic drum instrument for crisp Nordic pop, soft intimate beats, large analog bodies, glittering digital percussion and damaged club textures. This is a new instrument with its own original audio library and AU identity. THE HARDWARE EDITOR The main surface keeps ten pads in two rows, each with an independent Solo. Pad Edit at the right follows the selected pad and provides Sound, Pitch, Tone, Ring, Level, Pan, Room Send, High Pass and Low Pass. Edit Pad opens all remaining controls. Import accepts your own short sound; dropping onto a pad works too. The main Pitch, Velocity and Pan lane buttons select the sixteen step sliders. Higher values are toward the top. Step buttons enable or rest each hit. Song and Mixer occupy the center workspace while pads, Solo, all sixteen step buttons and the transport stay available. Close or Escape returns to the surface. Tube feeds Tape in the output stage; each switch remains independent. The meter shows actual combined gain reduction. Output sets the final listening level. Click LYNCH to read about Lynch Audio Lab and Robin Lynch. About and the Guide are integrated scrollable overlays; Close and Escape leave all sound settings intact. QUICK START Insert Electronic Drums+ as a software instrument. Choose a factory kit/pattern from Starting Points, then press PLAY even while Logic is stopped. HOST SYNC uses the host's beat while it advances; stopped-host preview continues at host BPM. With HOST SYNC off, BPM is your manual tempo. Click a pad to hear it and select its simple sixteen-step row. Click step numbers to enable or rest its hits. The Init button and host factory Init both load a clean source and simple beat; PLAY is off in the stored Init. The instrument does not start itself on insertion. Factory kit changes preserve your current Play, Host Sync, BPM and Song setting. YOUR OWN SOUNDS Drop WAV, AIFF/AIF or CAF onto a main pad, or use Import inside Edit Pad. Mono/stereo files, 8–192 kHz, up to 10 seconds, are converted to 48 kHz MONO. Original stereo width is not retained; set pad Pan for placement afterwards. Normal files keep their level; floating audio above full scale is reduced to fit. User Sample recalls the pad's import. Factory selections leave that import available. Clear User removes it and selects Follow Kit. An empty User Sample is silent. Imported sounds use the usual tuning, filtering, sends and step lanes. Audio is embedded in Logic state and saved .aupreset files, so the original file may be moved after saving. Larger samples produce larger project/preset files. REAL DRUMS Real Drums appears in the preset and pad sound selectors. It contains32 distinct rhythms and20 recorded acoustic source families (80 velocity/alternate samples). Acoustic Room and Live Kit are two processed palettes from existing VCSL sources, not two new drum-kit recording sessions. Kick, snare, hats, low tom, cross stick, tambourine, cowbell, crash and ride are included. In these presets Clap plays tambourine and Perc plays cowbell. Any sound can go on any of the ten pads. VCSL's CC0 license and precise sources accompany the product. Some alternates are processed variations. No Goldbaby samples are included. THE SOUND LIBRARY 160 newly synthesized original sound families, each with two velocity excitations and two alternating takes:640 48kHz mono samples. There are20 kick,20 snare,20 closed-hat,20 open-hat,20 clap and20 tom families,12 rims,12 percussion families, 8 FX and8 noise families. Any sound can go on any pad. Quiet hits have softer excitation; louder hits select the harder layer. Each pad advances its own two alternate takes. No commercial recordings or proprietary drum-machine samples are bundled. Clean, Punch, Fat, Grain and Tape choose the source bank for pads set to Follow Kit. Explicit per-pad sounds override that bank. The180 entries are grouped by type; FX and Noise include laser/FM chirps, glitch objects, short washes and sweeps. Source themes range from Glacier Pop, Glasshouse and Linen Machine to Fjord Analog, Magnetic Crush, Broken Glass and Arctic Voltage. These are original recipes; they are not measured replicas of named hardware. Historical inspiration includes analog ringing bass drums, noise/shell snares, metallic oscillator hats, clap pulse bursts, pitched toms and digital hybrid FM percussion. A fast pitch attack and separate body decay are synthesis building blocks. Three kick themes use pulse-excited damped resonators, with a distinct fast attack jump and slow pitch sigh; four snare themes use two pulse/noise-excited shell resonators. These are original behavioral models, not a claim that a sample plays the actual circuit's continuously retriggering state. This sampler has24 voices and retriggers individual samples. FACTORY STARTING POINTS Init plus288 arrangements in nine folders:256 electronic and32 Real Drums grooves. The electronic folders are: Nordic Pop, Electropop, Indie Electronic, Synth Pop, Alt RnB, Downtempo, Disco House and Leftfield. Each has a different complete ten-pad trigger arrangement, selected sounds, accents, per-step movement and a considered output treatment. Common musical kick/backbeat conventions are shared; these are not four drive settings of one underlying pattern. Use the arrows to browse, or select directly. Save writes a standard .aupreset. User loads your saved file. Sound, steps, pads, output stages and the sparse Song document travel with the host state. MAIN SOUND CONTROLS Tone moves the global brightness from a350Hz nominal low-pass cutoff to20kHz. It does not change sample tuning. Bright Init starts at100; use Pad Pitch for independent tuning. Tape mode has its own worn-speed coloration. Dirt adds oversampled asymmetric coloration. Space combines a short room and slap return; each pad has an independent Send into it. Motion adds subtle movement. Ring sets the common sample envelope decay; the per-pad Ring scales it. Output is manual level. SOUND ON/MUTED mutes this instrument; it is not an effect's dry bypass. PAD MIXER Mixer opens a compact ten-channel balance panel. Each pad has a Volume fader and Pan slider. These are the very same Level and Pan parameters used in Edit Pad: changes in either view, host automation and loaded presets update the other view. There is no extra gain stage or second set of mix settings. Double-click a control to reset it, or right-click for parameter reset and MIDI-assignment guidance. Click a pad name in Mixer to audition/select it. The main pads, Solo switches, sixteen-step row and Play remain accessible while Mixer is open. Close Mixer or Escape returns to the main sound controls. Mixer and Song occupy the same compact upper workspace; opening one closes the other. PAD EDIT Edit Pad opens above the instrument. You can click any of the ten pads or HIT while editing, and PLAY is also available inside the panel. The small S switches can solo several pads together. Auto Preview auditions changed selections after a gesture while the pattern is stopped. Previous/Next Sound browse all180 sources plus Follow Kit and User Sample. Previous/Next Pad change the edited pad. Level and Pan balance each sound. Pitch is live semitone tuning; Start skips into the sample and Reverse starts at the other end for the next hit. Attack softens the transient. Ring scales the envelope. Room Send ranges0–200% under master Space. Drive is asymmetric antiderivative-antialiased saturation. Electronic Distortion is a separate destruction stage with clipping/folding and crushed sample holds. At zero both preserve the clean sample; full Distortion intentionally gets rough. Tone is a complementary up-to6dB spectral tilt around1kHz. Separate12dB/oct High Pass and Low Pass remove lows/highs. HP at20Hz and LP at18kHz bypass their filter. These controls are smoothed and change already-ringing hits. Humanize adds independent positive timing jitter up to12ms and up to±18% velocity variation at full. Variation adds random pitch in cents per hit. Zero is exact. Auto Pan gives tempo-synced stereo movement around Pan; Rate selects its cycle. Chance affects sequencer hits, not clicked or incoming MIDI hits. Random streams are deterministic per pad and reset with the instrument, so block partitioning does not decide the sound. DUCKING All non-kick pads can choose Off, Kick, Snare or Kick+Snare. Duck depth reaches 48dB at full, with smooth short attack and independently set recovery. A source's actual pattern/MIDI/audition hit triggers its detector even when that source is hidden by Solo. Therefore a solo hat can still pump to the playing kick pattern. A disabled/rested/chance-skipped source step does not trigger. Snare cannot duck itself and Kick is exempt. The pad and its new room send duck together; already stored shared room tails continue naturally. KICK BASS AND RUMBLE The Kick pad has an additional bass/fattening control. Rumble opens its own panel: a tempo-synced eighth-note echo into a diffused low return, with Amount, Length, Duck, Recovery, Width, HP, LP and Drive. Dry kick stays intact. Low stereo content is centered below120Hz; Width affects the higher return. Rumble Solo hears only the return while kick hits still feed and duck it. Kick Solo includes its return. A stored factory Init has Rumble off. Most pop presets also leave it off. STEP PITCH / VELOCITY / PAN The main page stays simple. Step Edit opens three selectable lanes for the chosen pad. Pitch offsets are±24 semitones and are captured per hit, added to Pad Pitch. Velocity0 is a rest;127 is maximum. Per-step Pan offsets add to Pad Pan and are bounded to the stereo range. Auto Pan and Humanize remain independent. Reset Lane resets only that lane; changes are saved/automatable with their pattern. SONG / FOLLOW / LOOP EXPORT Song stores sparse independent patterns against DAW bar numbers. Unassigned bars inherit the base pattern, so the song can follow a long arrangement without allocating every possible bar. Copy/Paste carries pattern, Swing and step lanes. Follow in the main view follows the currently playing bar; turn it off to edit a fixed bar while audio keeps following the DAW. Bar numbers are one-based. Song playback uses actual host beat, meter and transport; an unavailable clock uses the ordinary preview. Meter-change warnings require the explicit Align operation so existing edits are not silently shifted. Drag MIDI on the main page exports the ordinary one-bar ten-pad grid. The Song panel's loop drag exports the host's current cycle when available, or your explicit bar range. Files contain tempo/meter, swing, notes, velocity, pitch bends and pan events. For independent pitch/pan, pads use separate MIDI channels with pitch-bend range messages. Logic/instruments can interpret those channels and controllers differently; keep Electronic Drums+ as the destination for the closest behavior. MIDI is the stored grid: random chance, humanize, sampled FX, room, rumble, output coloration and audio tails are not printed into MIDI. TUBE → TAPE OUTPUT The permanent bottom output panel keeps Tube before Tape. Enable either, both or OFF. Tube gives warm stereo-linked sample-peak control with Amount. Tape adds its own Drive, Ceiling and Release and follows Tube when both are enabled. Stages are independent; more drive changes sound and level. The gain-reduction history shows control activity. Use Output manually; no automatic gain matching. Tape Ceiling describes sample peaks after control/enable transitions settle, not a certified reconstructed true-peak ceiling. Clean Init leaves both off. HELP / AUTOMATION / STATE ? toggles explanations for controls. Guide is an integrated frontmost surface; Close or Escape returns to the instrument. UI Size offers75/85/100/115/130/150%. Optional Hover allows click-free control; Escape disables it, Shift gives fine movement. All750 scalar controls are host parameters, including all step lanes. Use Logic's Controller Assignments/automation for MIDI knob control. Sound menus, mode/power switches and step masks are discrete; continuous values are smoothed. Song's sparse arrangement is saved as an additional document, not thousands of host parameters. State files are checked for finite/ranged/valid values before mutation. Other Lynch product state files have a different AU identity. ENGINE / LIMITATIONS AU instrument: aumu/Ep01/LyPl; Apple-silicon macOS12 or later. The sampled source is48kHz/16-bit mono; output is mono or stereo at44.1/48/88.2/96/192kHz (and supported intermediate rates). Offline sources are synthesized at192kHz then properly low-pass-decimated. On upward transposition, prefiltered mip levels reduce aliasing; large pitch changes and intentional sample crushing still have audible tradeoffs. 24 overlapping voices use oldest-voice stealing. Global coloration has16 samples of declared latency. Tube/Tape have no lookahead. The host tail declaration is200s to cover the longest imported sample at−48 semitones, Tape's slower playback, human timing and room/rumble decay. Repeated triggering can keep producing new sound. Bank decoding/resampling runs at initialization, not inside the audio callback. Factory output/headroom is conservative, but combining many maximum pads/drive stages can require level adjustment. CPU depends on polyphony, sample rate and enabled coloration. Automated measurements do not replace final music listening, real Logic MIDI drag/automation checks or release signing. ORIGINAL AUDIO AND TECHNICAL REFERENCES The160 electronic families are original synthesis. The20 additional acoustic families use existing VCSL recordings. See REAL-DRUMS-PROVENANCE.json and VCSL-CC0.txt for their precise source and processing history. See the bundled SOUND-CATALOG.json and PROVENANCE.txt for provenance and exact hashes. Reusable private engine/UI/song/player code derives from the project's existing Techno Drums implementation; no former product is modified by this release. Primary historical context: Werner/Abel/Smith, DAFx2014, physically informed808 bass drum analysis: https://www.dafx.de/paper-archive/2014/dafx14_kurt_james_werner_a_physically_informed,_ci.pdf Roland, original909 history (analog drums and sampled cymbals): https://www.roland.com/global/promos/roland_tr-909/?lang=en-JM These references inform concepts; no external implementation or ROM audio is used. Song now uses a compact upper workspace. All ten main pads, their Solo switches, the selected pad's sixteen steps and Play remain visible and clickable below it. Select a Song bar, click a pad and edit its main step row without closing Song. The selected bar is pinned when edited; Follow continues to use the existing follow/pinned behavior. Edit Pattern opens the detailed per-step lane editor.